Aviation Accident Summaries

Aviation Accident Summary LAX94LA170

SANTA PAULA, CA, USA

Aircraft #1

N6434C

AERONCA 7BCM

Analysis

THE CFI WAS ADMINISTERING A BIENNIAL FLIGHT REVIEW TO THE PRIVATE PILOT. AFTER PERFORMING SOME MANEUVERS AT THE PRACTICE AREA, THE FLIGHT RETURNED TO THE DEPARTURE AIRPORT AND EXECUTED A TOUCH AND GO LANDING AND TAKEOFF. AFTER THE INITIAL LANDING, THE PRIVATE PILOT CLOSED THE CARBURETOR HEAT AND APPLIED FULL POWER. THE AIRPLANE'S ENGINE BEGAN TO SPUTTER AND LOSE POWER WHEN THE AIRPLANE WAS 100 FEET ABOVE THE GROUND. THE CFI ASSUMED THE CONTROLS AND LANDED ON THE REMAINING RUNWAY. DURING THE LANDING ROLL, THE CFI INTENTIONALLY GROUND LOOPED THE AIRPLANE TO PREVENT IT FROM COLLIDING WITH A DITCH AT THE DEPARTURE END OF THE RUNWAY. THE AIRPLANE COLLIDED WITH TWO VEHICLES DURING THE GROUND LOOP. THE INVESTIGATION REVEALED NO EVIDENCE OF ANY ENGINE PREEXISTING MALFUNCTIONS OR FAILURES. THE METEOROLOGICAL CONDITIONS WERE CONDUCIVE TO CARBURETOR ICING.

Factual Information

On February 24, 1994, at 1720 hours Pacific standard time, an Aeronca 7BCM, N6434C, collided with some vehicles after completing an emergency landing on runway 22 at Santa Paula Airport, Santa Paula, California. The emergency landing was preceded by a loss of power shortly after taking off from runway 22. The pilot and certified flight instructor (CFI) were conducting a local visual flight rules instructional flight. The airplane, registered to and operated by the dual student, and two ground vehicles sustained substantial damage. Neither the certificated commercial pilot/CFI nor the certificated private pilot/dual student was injured. Visual meteorological conditions prevailed. The flight originated at Santa Paula Airport at 1650 hours. The CFI reported in the Pilot/Operator Aircraft Accident Report, NTSB Form 6120.1/2, that he was administering a biennial flight review to the dual student. The flight proceeded to the practice area after departing Santa Paula Airport. After the dual student performed several maneuvers, the CFI instructed the dual student to return to Santa Paula Airport and execute a touch-and-go landing and takeoff. The dual student executed a normal landing on runway 22 and then closed the carburetor heat, applied power, and took off. When the airplane was about 100 feet above the ground with about 60 percent of the runway remaining, the engine "suddenly sputtered" and lost most of its power. The CFI assumed the controls, completely retarded the throttle, and executed an emergency landing. The airplane touched down on the runway near or abeam the opposite direction runway numbers. The airplane swerved to the right, and the CFI intentionally "ground looped" the airplane hoping to dissipate the energy (ground speed). The airplane spun around and struck two vehicles before stopping. This accident was reported to the National Transportation Safety Board by Mr. Adrian Grieve, Aviation Safety Inspector, Federal Aviation Administration (FAA), Van Nuys [California] Flight Standards District Office, on March 22, 1994. Inspector Grieve conducted the on-scene investigation. He reported that the examination of the airplane and engine disclosed no evidence of the preexisting malfunctions or failures. The engine operated normally during the postaccident engine run. Inspector Grieve said that the outside air temperature (OAT) was 50 degrees Fahrenheit and the humidity was between 60 to 80 percent. He reported that the OAT and prevailing humidity was conducive to carburetor icing conditions.

Probable Cause and Findings

the existing meteorological conditions that were conducive to carburetor icing.

 

Source: NTSB Aviation Accident Database

Get all the details on your iPhone or iPad with:

Aviation Accidents App

In-Depth Access to Aviation Accident Reports