Burlington, WI, USA
N7184G
Robinson R44
The helicopter sustained substantial damage when it impacted the ground after contacting a power line and pole during takeoff. The pilot's accident report stated, "I cleared the area did a slow vertical liftoff and a left pedal turn. I was instantly in the wires which were [approximately] 10-12 [feet] north of depot and [approximately] 14-15 [feet] high. Obviously I didn't see the wires and have never seen wires that close to a fuel depot. ... The tail rotor got in the wires first and actually 'reeled' me backwards into the pole. Then the main rotor made contact. Then we hit the ground. It took me a few seconds to kill the engine as we were being bounced around so violently." His safety recommendation was, "The wires should at the very least been marked or identified in some way. (sign, placard) Most importantly they shouldn't have been so close to fuel depot 15-20 [feet] or so low. They should have been underground."
On February 28, 2004, about 1200 central standard time, a Robinson R44 helicopter, N7184G, sustained substantial damage when it impacted the ground, after contacting a power line, while departing Burlington Municipal Airport (BUU), near Burlington, Wisconsin. Visual Meteorological Conditions prevailed at the time of the accident. The personal flight was operating under the provisions of 14 CFR Part 91 without a flight plan. The pilot and passenger reported no injuries. The flight's destination was the Grand Geneva Resort Airport (C02), near Lake Geneva, Wisconsin. The flight departed from Ann Arbor Municipal Airport (ARB), near Ann Arbor, Michigan, and landed at C02. C02 did not have fuel service. The pilot flew to BUU for fuel for the return flight to ARB that day. The pilot's accident report stated: I flew into Burlington from the south directly to the fuel depot. There was a fixed wing aircraft at the south of the depot (not fueling) so I wanted to stay as far left as I could because of rotor wash. I landed the craft near the north end of depot for same reason. After receiving fuel, did my preflight and started the aircraft. I cleared the area did a slow vertical liftoff and a left pedal turn. I was instantly in the wires which were [approximately] 10-12 [feet] north of depot and [approximately] 14-15 [feet] high. Obviously I didn't see the wires and have never seen wires that close to a fuel depot. ... The tail rotor got in the wires first and actually 'reeled' me backwards into the pole. Then the main rotor made contact. Then we hit the ground. It took me a few seconds to kill the engine as we were being bounced around so violently. The pilot did not indicate any mechanical malfunctions in reference to the flight on his report. His safety recommendation was: The wires should at the very least been marked or identified in some way. (sign, placard) Most importantly they shouldn't have been so close to fuel depot 15-20 [feet] or so low. They should have been underground. This was a very dangerous set-up.
The pilot's inadequate visual lookout and his failure to obtain/maintain clearance from the transmission wire during the takeoff. Factors contributing to the accident were the transmission wire and the pole.
Source: NTSB Aviation Accident Database
Aviation Accidents App
In-Depth Access to Aviation Accident Reports
