Ridgeway, VA, USA
N9416U
CESSNA 150M
The certified flight instructor (CFI) and his student completed the preflight inspection and engine run up. The airplane became airborne about 1/3 way down the runway, climbed slowly and collided with trees at the departure end of the runway. The airplane descended, impacted the ground and came to rest inverted. A postaccident examination revealed the airplane was at or slightly over the maximum takeoff weight, and the flaps were set at 10-degrees. According to the airplane's pilot operating handbook, the best rate of climb with no obstacles should be performed with zero flaps. The CFI reported that there were no anomalies that would have precluded normal operation.
According to the flight instructor, he and the private pilot under instruction filled the fuel tanks, performed a preflight inspection, taxied to the runway and completed an engine run up. They began the takeoff roll, with the flaps set at 10 degrees, from the 3,000-foot-long,up-sloped, turf runway and the airplane became airborne about one-third down the runway. The airplane climbed slowly and the flight instructor realized that it would not be able to clear the trees at the end of the runway. The private pilot applied the left rudder in order to turn the airplane and stay clear of the trees, but soon the instructor took the flight controls because he realized that the airplane was going to impact the trees. The airplane struck the trees approximately 20 feet from the tops, impacted the ground, and came to rest inverted. During the accident sequence, the fuselage, wings, and empennage were substantially damaged. The flight instructor reported there were no preexisting mechanical anomalies with the airplane. Weight and balance calculations revealed that the airplane was at or slightly over the maximum takeoff weight provided by manufacturer. Also, the owner's manual stated that the best rate of climb was with flaps up and that the "use of 10 degrees of flaps is reserved for minimum ground runs or for take-off from soft or rough fields with no obstacles ahead."
The pilot's decision to takeoff using a flap setting higher than the manufacturer's recommended setting for takeoff.
Source: NTSB Aviation Accident Database
Aviation Accidents App
In-Depth Access to Aviation Accident Reports
