Alva, OK, USA
N929JV
Eurocopter SA315B
The helicopter was flying at 300 feet above the ground with an external load when the pilot heard a loud noise from the engine and the rotor rpm began to decay. He jettisoned the load and entered an autorotation. During the flare, the helicopter's main rotor blades contacted the tail rotor drive shaft. Engine disassembly and examination revealed that the turbine casing was deeply eroded by particles that had accumulated in the casing as a result of operating in dusty environments. The erosion caused a crack to develop, and non-uniform overheating of the engine led to the partial melting of the nozzle guide vanes and the rupture of the blade tips in all three turbine stages. Uncontained debris then punctured the turbine casing and shroud. According to the helicopter's maintenance records, the helicopter had operated 68 hours past a 100-hour inspection. The erosion in the engine was likely preexisting since it had been purchased second hand. Further, the records contained no entries pertaining to compliance with the manufacturer's maintenance procedures, by either the current or previous owner, for operations in sandy environments. The current operator reported that they have since complied with the manufacturer’s procedures.
On March 30, 2012, about 0943 central daylight time, the pilot of a Eurocopter SA315B, N929JV, made a forced landing in an open field about 25 miles northwest of Alva, Oklahoma, after the engine lost power. The pilot, the sole occupant on board, was not injured. The helicopter was substantially damaged. The helicopter was registered to Roberts Aircraft Company, Cheyenne, Wyoming, and operated by Trans Aero, Ltd., of Longmont, Colorado, under the provisions of 14 Code of Federal Regulations (Part 133 as an external load operation. Visual meteorological conditions prevailed at the time of the accident, and no flight plan had been filed. The local flight originated from Alva, Oklahoma, about 0830. According to the pilot's statement, he was flying at 300 feet above the ground with an external load. He heard a loud noise from the engine and the rotor rpm began to decay. He jettisoned the load and entered an autorotation. During the flare, the helicopter's main rotor blades contacted the tail rotor drive shaft. The helicopter tilted up on its nose then settled back on its skids. The engine was removed from the airframe and shipped to Turbomeca in Tarnos, France, where it was disassembled and examined under the oversight of the Bureau d’Enquêtes et d’Analyses (BEA), the French aircraft accident investigation bureau. According to Turbomeca's report, which was endorsed by BEA, the turbine casing was deeply eroded by particles that had accumulated in the casing as a result of operating in dusty environments. The erosion caused a crack to develop, and non-uniform overheating of the engine led to the partial melting of the nozzle guide vanes and the rupture of the blade tips in all three turbine stages. Uncontained debris then punctured the turbine casing and shroud. Turbomeca Procedure 72-40-01, page 203, describes how sand deposits were to be eliminated. There was nothing in the helicopter's engine maintenance records to indicate that this procedure had been performed.
Failure of the current and previous operators to comply with the manufacturer's maintenance procedures for operation in sandy environments, which resulted in turbine case erosion and the subsequent uncontained engine failure.
Source: NTSB Aviation Accident Database
Aviation Accidents App
In-Depth Access to Aviation Accident Reports
