Pearland, TX, USA
N557CL
ROE CLEO WITTMAN TAILWIND W10
The private pilot was departing for a local flight in the experimental, amateur-built airplane, which he had recently purchased. Airport surveillance video showed the airplane in a nose-high attitude and the wings rocking left and right during the initial climb. After a brief period of straight and level flight, the airplane entered a steep left turn with a nose-high attitude. The left wing dropped, and the airplane entered a nose-down spin that continued to ground impact.The postaccident airframe and engine examination did not reveal evidence of any preimpact anomalies that would have precluded normal operation. It is likely that the pilot failed to maintain adequate airspeed during the climbing turn after takeoff and exceeded the airplane's critical angle of attack, which resulted in an aerodynamic stall/spin. Although the pilot had received 1.0 hours of flight training in the accident airplane in the 30 days before the accident, he only performed 2 solo takeoffs and landings. This training did not include training on stall characteristics, which the Federal Aviation Administration recommends. If the pilot had received stall training in the airplane, he would likely have been aware of the appropriate airspeeds and pitch attitudes to use while maneuvering after takeoff, and this may have prevented the accident.
HISTORY OF FLIGHTOn October 26, 2016, about 1730 central daylight time, an experimental amateur-built Wittman Tailwind W-10 airplane, N557CL, was destroyed when it impacted terrain on the eastern edge of Pearland Regional Airport (LVJ), Pearland, Texas. The private pilot was fatally injured. The airplane was registered to and operated by the pilot under the provisions of Title 14 Code of Federal Regulations Part 91 as a personal flight. Visual meteorological conditions prevailed for the local flight, and no flight plan had been filed. The airplane departed on runway 14 at LVJ just before the accident. One witness at the airport stated that he saw the airplane climb out in a "nose high" attitude. Another witness at the airport stated that the airplane's flight "was uncoordinated to the point that it did not look right." Both witnesses reported seeing the airplane enter an uncoordinated turn, then enter a stall/spin. These witnesses as well as a third witness said that the airplane's engine was at full power. Video captured on an airport surveillance camera showed the airplane departing runway 14 in a nose-high attitude. During climbout, the wings were rocking left and right. At an altitude about 500 ft above ground level, near midfield, the airplane entered a left turn. The airplane then leveled to straight and level flight for a brief period before entering a steep left turn with a nose-high attitude. The left wing dropped, and the airplane entered a nose-down spin to the left and completed one full rotation before impacting the ground. PERSONNEL INFORMATIONThe pilot, age 36, held a private pilot certificate with an airplane single-engine land rating. His Federal Aviation Administration (FAA) third-class airman medical certificate was issued on April 21, 2016, with no limitations. The pilot's logbook indicated that he had 243.2 hours of flight experience as of October 20, 2016, with 1.3 hours in the accident airplane. The pilot's last flight review was completed on February 6, 2016. According to the logbook, the pilot had a total of 22.3 hours in Wittman Tailwind airplanes, 3.2 hours of which were training. He received 2.2 hours of transition training in a Wittman Tailwind W-8 a few weeks before purchasing the accident airplane, and 1.0 hours of training in the accident airplane on October 20, 2016, when he purchased the airplane. All of the training was provided by the same flight instructor. The flight in the accident airplane consisted of 5 takeoffs and landings with the instructor, followed by 2 solo takeoffs and landings. AIRCRAFT INFORMATIONThe airplane's experimental airworthiness Certificate was issued on November 11, 1992. The airplane was a two-seat, high-wing, tailwheel airplane, and it was powered by a 150-horsepower Lycoming O-320-E2D engine driving a fiberglass-composite, 2-blade, fixed-pitch Catto propeller. The most recent condition inspection was completed on October 2, 2016, at 642.7 hours total time. The airplane was equipped with a header fuel tank that held 33.1 gallons. Refueling records revealed that the airplane had been most recently refueled at 1705 the day of the accident with 8.1 gallons of 100 low lead aviation fuel at LVJ. METEOROLOGICAL INFORMATION At 1653, the automated surface observing system at LVJ reported wind from 110° at 8 knots, visibility 10 miles, temperature 29° Celsius (C); dew point 17°C, and an altimeter setting of 30.10 inches of mercury. AIRPORT INFORMATIONThe airplane's experimental airworthiness Certificate was issued on November 11, 1992. The airplane was a two-seat, high-wing, tailwheel airplane, and it was powered by a 150-horsepower Lycoming O-320-E2D engine driving a fiberglass-composite, 2-blade, fixed-pitch Catto propeller. The most recent condition inspection was completed on October 2, 2016, at 642.7 hours total time. The airplane was equipped with a header fuel tank that held 33.1 gallons. Refueling records revealed that the airplane had been most recently refueled at 1705 the day of the accident with 8.1 gallons of 100 low lead aviation fuel at LVJ. WRECKAGE AND IMPACT INFORMATIONThe main wreckage was located in a grassy area on the east side of LVJ. The aircraft came to rest at a magnetic heading of 315º at an elevation of 54 ft. The airplane sustained aft crushing of the nose and forward fuselage section, as well as impact damage to the leading edge of the right wing from the wingtip to the wing strut. The damage appeared to be consistent with a nose and right wing-low impact with the ground. Fuel blight was observed on the grass surrounding the wreckage of the aircraft. Flight control continuity was established for all flight control surfaces up to the cockpit. Continuity to the controls inside the cockpit could not be established due to impact damage. The propeller was embedded about 10 inches into the ground, and both blades were broken off consistent with impact forces. The propeller hub and remnants of the propeller spinner remained attached to the crankshaft flange. The propeller spinner displayed damage signatures that were consistent with engine power at the time of impact. The engine was rotated by hand from the vacuum pump pad, and thumb compression was observed at all cylinders except for the No.1 cylinder. Valve train and crankshaft continuity were confirmed by observation of normal rocker and valve movement and rotation of all accessory gears. The No. 1 cylinder was removed and examined. The cylinder barrel was leak checked using water, and there was no drainage through the valves. The cylinder walls were unremarkable. The piston and rings were intact and unremarkable. The loss of compression on the No. 1 cylinder was consistent with an extended wear pattern and loss of ring tension on the piston rings. The carburetor was destroyed by impact, and no fuel was observed in the carburetor components. The engine-driven diaphragm fuel pump was removed and actuated by hand; thumb compression was obtained. The fuel gascolator screen was removed and found to be unremarkable. The left magneto was found broken from the accessory housing. It was rotated by hand, and a spark was obtained from all outlet points. The electronic Plasma ignition located in the right magneto position was secure; it was removed and examined but was unable to be tested due to impact damage. The top spark plugs were Denso automotive plugs. An automotive spark plug wiring harness had been installed to the top spark plugs. The harness was observed undamaged but was not tested. The bottom spark plugs were Tempest Urem 38E massive electrode plugs. The Bendix ignition leads attached to the bottom spark plugs were destroyed by impact. The starter and alternator were attached to their respective mounts but were destroyed by impact. The oil system was destroyed by impact. The oil suction screen and the oil pressure screen were observed free of contaminants. Some of the oil carrying lines were broken during impact. Examination of the airframe and engine revealed no evidence of anomalies that would have precluded normal operation. ADDITIONAL INFORMATIONAirplane Transition Training Guidance FAA Advisory Circular (AC) 90-109A, "Transition to Unfamiliar Aircraft," recommends training for pilots transitioning to any unfamiliar fixed-wing airplane, including type-certificated or experimental airplanes. The AC states that "accident analysis indicates that subsequent owners and/or pilots of experimental and/or unfamiliar airplanes have a higher accident rate during initial flight time than did the original owner. Therefore, the recommendation is that the subsequent owners/pilots of experimental airplanes receive airplane-specific training before operating the airplane." The AC provides training guidance for flight instructors who teach in these airplanes. It recommends that training cover stall characteristics, including the airplane's slow flight behavior and response to control inputs at slow speeds. According to the AC, most of the pilot's total flight time was in airplanes with flight characteristics that could be defined as "Low-Inertia and/or High-drag." The Wittman Tailwind airplane has flight characteristics that are considered "High-Inertia and/or Low Drag" with "Light control Forces and/or Rapid Airplane Response." During an interview conducted by an FAA inspector, the flight instructor who provided training to the pilot in the accident airplane stated that she did not provide training on stall characteristics as recommended in the AC. The instructor pilot was asked if the pilot had difficulty keeping the airplane in coordinated flight, to which she replied, "he was having an issue with that and did better on his last few flights." MEDICAL AND PATHOLOGICAL INFORMATIONThe County of Galveston, Medical Examiner's Office, Texas City, Texas, conducted an autopsy of the pilot. The cause of death for the pilot was attributed to "blunt force injuries." The FAA Bioaeronautical Sciences Research Laboratory, Oklahoma City, Oklahoma, performed toxicology testing on specimens from the pilot. The toxicology results were negative for carbon monoxide, ethanol, and drugs.
The pilot's failure to maintain adequate airspeed and his exceedance of the airplane's critical angle of attack during a climbing turn after takeoff, which resulted in an aerodynamic stall/spin. Contributing to the accident was the pilot's inadequate training in the airplane, which did not include training on the airplane's stall characteristics.
Source: NTSB Aviation Accident Database
Aviation Accidents App
In-Depth Access to Aviation Accident Reports
