Garberville, CA, USA
N3453K
PIPER J3C-65
The pilot was landing the tailwheel-equipped airplane when the accident occurred. He reported that, after conducting a wheel landing, the airplane veered to the right as the tailwheel touched down. He attempted to abort the landing; however, the airplane did not have enough airspeed and exited the right side of the runway, where it impacted an unoccupied parked airplane. Postaccident examination of the airplane’s tailwheel revealed that when installed on the airplane, it remained within the steering detents. When sufficient force was applied, the tailwheel traveled beyond the detent to the left; however, it did not travel beyond the detent to the right. In addition to the tailwheel spring clip, a braided portion of safety wire was attached to the steering arm and connector spring assembly. Once removed, the tailwheel functioned normally. Disassembly of the tailwheel did not reveal any preaccident mechanical failures or malfunctions that would have precluded normal operation. It is likely that, while the tailwheel assembly was connected to airplane, the safety wire installed between the steering arm and connector spring assembly would not allow the tailwheel to rotate beyond the detent when moved to the right. However, the tailwheel not traveling beyond the detent to a full-swivel condition would not have prevented the pilot from maintaining direction control while landing.
On October 4, 2021, about 1200 Pacific daylight time, a Piper J3C-65, N3453K, was substantially damaged when it was involved in an accident near Garberville, California. The pilot and passenger were not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight. The pilot of the tailwheel equipped airplane reported that, following a wheel landing, as the tailwheel touched down, the airplane veered to the right. The pilot attempted to abort the landing; however, the airplane did not have enough airspeed, and was “totally out of control.” The airplane subsequently exited the right side of the runway and impacted an unoccupied parked airplane before it came to rest upright. Postaccident examination of the airplane by a Federal Aviation Administration inspector revealed that the right wing and both wing lift struts were substantially damaged. Flight control continuity was established from all primary flight control surfaces to the cockpit controls. The examination also showed that the airplane’s tailwheel rotated to the left, stopped at the detent and then swiveled freely when force was applied to the tailwheel. However, when tailwheel was rotated to the right, the tailwheel stopped at the detent and did not swivel beyond the detent when pressure was applied. The tailwheel assembly was removed from the airplane and examined. Examination revealed that the tailwheel did not have any visible damage. Both left and right compression spring assemblies had been disconnected from the tailwheel steering arm. One spring and chain connector clip was not present; however, a braided portion of safety wire remained attached to steering arm, where the clip would normally be installed. The tailwheel rotated left and right and remained within the steering detents. When sufficient force was applied to the tailwheel both to the left and right directions, it rotated past the detent and fully swiveled. The tailwheel was disassembled and no preaccident mechanical failures or malfunctions were observed that would have precluded normal operation. A review of the airplane maintenance records did not reveal any recent maintenance conducted on the tailwheel assembly.
The pilot's failure to maintain directional control during the landing roll, which resulted in a runway excursion and subsequent collision with an unoccupied parked airplane.
Source: NTSB Aviation Accident Database
Aviation Accidents App
In-Depth Access to Aviation Accident Reports
